3 FAQs
Q1: I enter the device’s LAN IP address in the web browser but cannot access this device’s
web UI. What should I do?
1) Verify that the IP address of computer should be a different one but on the same network
segment as the LAN IP address of this device. The default LAN IP address of AP is 192.168.0.254
and you need to set your PC to a static IP address within the following range: 192.168.0.X
(2~253);
2) Clear the browser cookies or try another web browser;
3) Close the firewall of your computer or try another computer;
If you are still unable to login, please restore the device to factory default settings and follow this
Install Guide to configure your settings again.
Q2: How do I restore my AP to its factory default settings?
Method 1: Via the RESET button
With the AP powered on, slide the bottom cover of the AP down to expose the RESET button,
press and hold it for over 7 seconds to restore the AP to its factory defaults. Note that once your
AP is reset, all your current settings will be lost and you need to reconfigure your AP.
Method 2: Via the Web UI
Log in to this device’s web UI, click Tools > Configuration > Restore to Factory Default to
reset the AP to its factory defaults.
To Next Page
Loading...
