iPECS eMG80
Hardware Description and Installation Manual Issue 1.3
93
5 At the back of LIP-9048 DSS and phone, remove the rubber plug from the Accessory
Expansion Module (AEM) port.
6 Plug the 12-Pin cable into the AEM port on LIP-9048 DSS and phone.
7 Place the Wire Protective Cover behind the LIP-9048 DSS and align the screw holes
with the Wire Protective Cover screw holes on LIP-9048 DSS.
8 Tighten the screw to secure the Wire Protective Cover.
See Button kit for the LIP-9000 Series or LIP-9048DSS Quick Installation Guide for more
detailed instruction.
Caution!
To avoid damaging the Phone or Button kit, remove power from the phone before
installing a Button kit.
To Next Page
