iPECS eMG80 - Page 99

iPECS eMG80
Hardware Description and Installation Manual Issue 1.3
92
Power Mode: The MODE switch is used to choose the power mode between Slave and
Master.
Symbol
Mode
Mode
Description
S Slave 5V
LIP-9048DSS receives power
from another DSS.
M Master 48V
LIP-9048DSS provides power
itself.
Protocol Type: The TYPE switch is used to choose a call protocol type between iPKTS
and SIP.
Symbol
Mode
Description
1 iPKTS
iPKTS protocol type of communication
supported.
2 SIP
SIP protocol type of communication
supported.
PoE Class: The PoE (Power over Ethernet) Class is indicated the class of the Powered
Device (PD), and CLASS switch is used to select the PoE class. DSS module supports all
4 classes listed in below table.
Class
Power
Ranges
Description
1
0.44W to
3.84W
-. One LIP-9048DSS or two LIP-9048DSS
2
0.84W to
6.49W
-. One LIP-9048DSS with a LIP-9020
-. Two LIP-9048DSS with a LIP-9020
3
0.49W to
12.95W
-. One LIP-9048DSS with a LIP-9030
-. Two LIP-9048DSS with a LIP-9030
-. One LIP-9048DSS with a LIP-9040
-. Two LIP-9048DSS with aLIP-9040
The default switch position is '0'.
• '0' means the power OFF status and it does not support PoE power.
• '1' means the power ON status and it does support PoE power.
1 Set the power mode, protocol type, and PoE class in advance as described above.
2 Make sure that the Joint Bracket is aligned with the side of the LIP-9048 DSS, and
insert the one side of the Joint Bracket into the mounting holes.
3 And insert the other side of the Joint Bracket into the mounting holes on the side of
your phone.
4 Use the provided screws to connect the LIP-9048 DSS and phone firmly together.