iPECS eMG80 - DSS;BLF Console Installation & Wiring

iPECS eMG80
Hardware Description and Installation Manual Issue 1.3
87
3. Use the Volume Up/Down buttons to scroll through the menu shown below.
4. Enter appropriate values for the local network.
5. When complete, press the Speaker button.
6. Press ‘*’ to exit and restart the LIP Phone.
Menu Display
Description
MODE[R/L]
[LOCAL] – CHANGE[#]
Registration mode, use ‘#’ to set Remote mode
PHONE IP ADDRESS (DOT:*) Use the dial pad to enter the fixed IP address,
use DHCP for dynamic addressing
PHONE NET MASK(DOT:*) Use the dial pad to enter the Subnet mask if
using fixed IP addressing
ROUTER IP ADDRESS(DOT:*) Use the dial pad to enter the default Gateway if
using fixed IP addressing
MFIM IP ADDRESS(DOT:*) Use the dial pad to enter the IP address of the
MFIM IP address.
SAME LAN WITH MFIM
[YES] – CHANGE[#]
Indicates if the IP Phone and the eMG80 are on
the same LAN segment. Use # to change,
Yes/No.
INPUT DEVICE NUMBER:
DHCP ?
[DISABLED] – CHANGE[#]
The IP Phone supports fixed or dynamic
addressing, use # to change the value.
VLAN CONFIGURATION
NOT SET
Not used
WEB PASSWORD Not used
PHY MODE : AUTO NEGO
CHANGE[*] SAVE[#]
Speed and Duplex negotiation, use * to change
the selection
7.3.4 DSS/BLF Console Installation & Wiring
The digital LDP-7048 DSS/BLF Console is provided with a phone-mounting bracket so that
the console can be securely fastened to the corresponding LDP-7000 phone. To attach the
console to the phone, refer to
LDP-7048 DSS Installation
Figure 7.3.4-1 and the following instructions
1. Turn the Console and phone upside down.
2. Place the fastener in position as shown in figure balloon.
3. Insert and tighten screws. Caution, do not over-tighten the screws as this will
damage the plastic hosing.