iPECS eMG80 - Page 98

iPECS eMG80
Hardware Description and Installation Manual Issue 1.3
91
Figure 7.3.4-4 LIP-9000 DSS Installation
The Button kit should be installed on the phone prior to making any connections to the
phone. This simplifies the installation.
To install the button kit for the LIP-9012 DSS, LIP-9024 DSS and LIP-9024 LSS
1. First, assure the phone is NOT connected to power.
For convenience, you may wish to remove the
handset and foot-stand; this simplifies the Button kit
installation.
2. On the right side of the phone, remove the Button
kit cover.
3. Align the Button kit and phone as shown in the
drawing.
4. Push the Button kit into the phone until the button kit is fully engaged.
5. Insert the screws provided through the screw tabs in the Button kit and tighten the
screws into the phone. Do not over-tighten.
To install the button kit for the LIP-9048DSS
Prepare your LIP-9048DSS for connection depending on the type of LIP phone. The
setting switches are hidden on the back of right side of the LIP-9048 DSS. Before you
begin, remove protective cover from the LIP-9048 DSS.