iPECS iPECS-LIK - Page 16

iPECS-LIK
Feature Description & Operation Manual Issue 6.0d1
3
Table 1.2-1 System Capacity Chart
Item
iPECS-Micro
iPECS-50
iPECS-100
(MFIM100)
iPECS- 300
(MFIM300)
iPECS-600
(MFIM600)
iPECS-1200
(MFIM1200)
Station & Hunt
Group Members
26
50
70
70
70
200
Pickup Group
20
20
30
100
150
200
Pickup Group
Member
26
50
70
300
600
1200
Conf. Grps -
System
20
20
20
40
80
160
Station
25
25
35
150
300
600
Executive/Secretary
pairs
10
10
10
36
36
100
Authorization
Codes
Station
26
50
70
300
600
1200
System
474
450
430
700
1400
2800
Total
500
500
500
1000
2000
4000
VSF
*3
280(245)
minutes
(4 channels)
280(245)
minutes
(6 channels)
210(175)
minutes
(6 channels)
210(175)
minutes
(6 channels)
n/a
n/a
VMIM
n/a
9 hrs
9 hrs
9 hrs
9 hrs, max x 6
9 hrs, max x 30
MCIM
1
2
2
4
8
30
WTIM
16
16
16
32
32
32
VoIP channels
*4
5 std.
Std. 4-8
6 std.
6 std.
n/a
n/a
Redundancy
No
No
Yes
Yes
Yes
Yes
SIP channels
(Stations + CO
lines)
Same as
system port
Same as
system port
100
200
200/100
Note5
500
Note 1
The station and CO Line maximums are not simultaneously achievable ; total ports cannot
exceed the specified System Port capacity.
Note 2
For maximum RSGM connection ports, calculation formula is ports = available system station
ports)/2, there must be sufficient VoIP channels to support packet relay for RSGM rtp packets.
Note 3
Approximately 35 minutes (16 Mbytes) of the VSF memory are used to provide basic system
prompts, the remaining memory can be used for announcements and voice message storage.
Values in parenthesis are the announcement and storage time available.
Note 4
Using G.711 codecs, 8 VoIP channels are available. Due to additional processing needs,
complex codecs reduce the available channels; four (4) channels are available using G.723
or G.729.
Note 5
Issue 0, 1, 2 : Support up to 100 channels (SIP extension + CO trunk) simultaneously Issue
3 : Support up to 200 channels (SIP extension + CO trunk) simultaneously
Note 6
Only Issue 3 MFIM MPB’s ( specifically MFIM100, 300, 600) are suitable/supported for
upgrade to Phase 6 firmware versions. Attempts at upgrading the older MFIM MPB versions
( i.e. issue 0,1 and 2 ) will result in MFIM database and functional failure.
The MFIM50A/B, and MFIM1200 are excluded from this rule.