iPECS iPECS-LIK - System Speed Zone (Groups)

iPECS-LIK
Feature Description & Operation Manual Issue 6.0d1
158
Conditions
1. Accessing an empty Speed Dial bin will return error tone.
2. A Speed Dial number can be assigned to use a CO/IP Line/Group. If the assigned
line is busy, a line from the same group will be selected. If all lines in the group are
busy, the user may queue for the next available line.
3. All Speed Dial numbers are stored in memory protected from power loss.
4. The CO/IP line used for a Speed Dial is presented to a direct appearance on the
iPECS Phone. If there is no direct appearance at the station, a {POOL} or {LOOP}
button is used as the appearance for the line.
5. The user may pre-select the CO/IP line for a Speed Dial number, overriding the
CO/IP line assignment in the Speed Dial bin.
6. A name can be entered for a Speed Dial number to permit access from the Dial-by-
Name directory.
7. If a Speed Dial number contains a “Dial Tone Detect” command, Flash as the first
entry in the bin, and dial tone detect is enabled for the CO line, the system must
detect dial tone before dialing the Speed Dial number.
Programming
STATION
1 Speed Dial Access (PGM 112-Btn 8)
SYSTEM
1 CO Dial-Tone Detect (PGM 160-Btn 3)
TABLES
1 System Speed Zone (PGM 232)
Related Features
 CO Line Flash
 Dial-by-Name
 Display Security
 Keypad Facility
 LNR (Last Number Redial)
 Dial Pulse to Tone Switchover
 Save Number Redial (SNR)
 Speed Dial Pause Insertion
 System Speed Dial
 System Speed Zone (Groups)
Hardware
2.64.5 System Speed Zone (Groups)
Description
System Speed Dial bins can be divided into zones or groups. iPECS systems have 10 zones
available, except for the iPECS 600(1200), which has twenty (fifty) zones. To access a Speed
Dial bin assigned to a zone, the station must be allowed access to the Speed Dial Zone.
In addition, each zone can be assigned to apply COS dialing restrictions to the Speed Dial
numbers in the zone. When assigned, the system will apply the Station and CO/IP COS to calls