iPECS-LIK
Feature Description & Operation Manual Issue 6.0d1
404
Registration from the SIP Phone during the Registration Timer then system will
disconnect the SIP Phone automatically after Registration Timer expires.
− Manual : Re-Registration is not required for the SIP Phone
1. SIP Data / SIP Phone Attributes(211) – TRANSPORT
− by default, UDP
− TLS : you need to set the Encryption Key. More technical information may be
required for you.
2. SIP Data / SIP Phone Attributes(211) – SIP Phone Type
− Automatically determined by system
3. SIP Data / SIP Phone Attributes(211) – Device NAT Usage
− AUTO : system determine automatically
Multi Line support for a SIP Phone
1. LIK allow multiple Extension for a SIP Phone that support Multi Line.
2. A SIP Phone will implement multiple register to system.
3. System will distinguish them by,
− 1
st
Extension : write it as a device with original MAC address
− from 2
nd
Extension : write it as a device with virtual MAC address
Conditions
1. You need to install Lock-Key for SIP Phones except Ericsson-LG LIP8002,
WIT400H, Yamaha ACT-50(PJP-50).
Programming
1 SIP Attributes (210)
2 SIP Phone Attributes (211)
3 SIP Phone Provisioning (212)
Related Features
Hardware
MFIM1200:
Support up to 600 channels (SIP extension + CO trunk) simultaneously
MFIM600:
Issue 0, 1, 2: Support up to 100 channels (SIP extension + CO trunk) simultaneously
Issue 3 : Support up to 200 channels (SIP extension + CO trunk) simultaneously
MFIM300:
Support up to 200 channels (SIP extension + CO trunk) simultaneously
MFIM100:
Support up to 100 channels (SIP extension + CO trunk) simultaneously
iPECS-50A/B, Micro:
Support SIP extension and CO trunk according to the maximum station and CO lines.
To Next Page
Loading...
