irinox Freddy 60 - Installation; Installation Rules; Warnings for the Installer

10 Freddy
Installation
Installation rules
Warnings for the installer
This manual is an integral part of the product and
provides all necessary indications for a correct
maintenance and installation of FREDDY.
THE user and installer must carefully read this manual
and always refer to it. It must also be kept in a place
known and accessible to all authorised operators
(installer, user, maintenance technician).
The manual must be stored in a dry place.
Irinox SPA declines any responsibility and warranty
obligation for damages to the appliance, people or
property caused by:
• wrong installation and/or not complying with current
laws;
• changes or actions not specic for that model;
• use of non-original spare parts or non specic for that
model;
• non-observance, even partial, of the instructions
contained in this manual;
• non-observance during installation of the accident
prevention standards and current laws on the matter.
Introduction
Installation must be only carried out by authorised and
qualied personnel, in compliance with the instructions
and provisions contained in this manual.
Before installing the appliance check that pre-existing
electric systems are compliant with and adequate to
the data stated on the plate of the equipment to be
installed (voltage [V], frequency [Hz], power [W]).
Irinox SPA states and supplies with every machine a
declaration of conformity to the current regulations.
Transport and handling
The appliance loading and unloading from the vehicle
must be performed using adequate means or by two
people (g. 1).
Take all necessary precautions while handling the
appliance to avoid damaging it and damages to
people and property. Always follow the indications
of the package.
Fig. 1
Unpacking
Remove the cardboard package and extract the
appliance by removing the internal protections.
(Fig. 2).
Fig. 2
1. After removing the package, check straight away the
conditions of the appliance; in case of faults do NOT
operate FREDDY and contact Irinox SPA.
2. Use protective gloves to lift the appliance and place it
in the intended place. This operation must be carried
out by two people.
3. Remove the PVC protective lm from all sides with
care; in case of adhesive traces left on the surfaces,
gently remove them with a soft cloth and a neutral
product. It is recommended not to use stainless steel
scourers, scrapers or abrasive, acid or aggressive
substances that could permanently damage the
appliance surfaces.