irinox Freddy 60 - BLAST CHILLING +3 °C Cycle MANUAL Cycle (with timer)

22 Freddy
BLAST CHILLING +3 °C cycle
MANUAL cycle (with timer)
Select COLD FUNCTIONS.
COLD
FUNCTIONS
Select BLAST CHILLING +3 °C cycle.
Select MANUAL WITH TIMER Key.
User guide
Press the
?
key to view a short description as information window. The
key makes you go back to the previous page.
The key makes you go back to the initial screen.
START
Start cycle.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side .
The blast chilling time, 1h by default, is shown in the middle.
Press on the central active area to access the time editing screen.
The blast chilling time setting screen will appear.
The minimum value that can be displayed and set is 1 min., while the
maximum value is 2 h.
To edit the time press the
+
-
keys to increase or decrease the time by 1
min.; if you wish to increase or decrease the time in a faster manner, use the
horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
Press the
START
key to start the blast chilling +3 °C cycle.
During operation the display shows the blast chilling cycle time left (in hours,
minutes and seconds) that can be edited by selecting . You will access
the time editing screen which is the same described above. The temperature
inside the chamber detected by the air probe is shown at the top right-hand
side.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial cold functions screen.
+8°C
?
STOP
0:15:28
3h:30'
SAVE
- +
+
+3°C
?
START
1h:00
AUTOMATIC
WITH CORE
PROBE
TIMED
MANUAL