irinox Freddy 60 - STORAGE Cycle

Freddy 59
MAINTENANCE cycle
+3°C
?
START
60°C
35°C
SAVE
- +
+
?
0:15:28
+25°C
STOP
?
+35°C
+25°C
STOP
Select HOT FUNCTIONS.
HOT
FUNCTIONS
Select MAINTENANCE cycle.
User guide
Press the
?
key to view a short description as information window. The
key makes you go back to the previous page.
The key makes you go back to the initial screen.
START
Start cycle.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side .
The storage temperature, +60 °C by default, is shown in the middle of the
screen (air temperature can be edited during storage phase).
Press on the central active area to access the storage air temperature editing
screen.
The screen for storage air temperature setting will appear (the temperature
range can be set between +20 °C and +85 °C). Press the
+
-
keys to edit
the temperature increasing or decreasing it by 1 °C. If you wish to increase or
decrease the temperature in a faster manner, use the horizontal dragging.
Press the
SAVE
key to conrm the temperature modication, while press
to go back to the previous screen without saving any change.
Press the
START
key to start the cycle. During the customised storage phase,
the time elapsed from cycle start is displayed (cycle duration time).
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side .
Press on the central active area to view the temperature inside the chamber
detected by the air probe of the customised storage cycle.
Press on the central active area again that shows the temperature inside the
chamber detected by the air probe to go back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial cold functions screen.