irinox Freddy 60 - SOFT FREEZING -18 °C Cycle Manual CYCLE (with timer)

26 Freddy
SOFT FREEZING -18 °C cycle
Manual CYCLE (with timer)
Select COLD FUNCTIONS.
COLD
FUNCTIONS
Select SOFT FREEZING -18 °C cycle.
Select MANUAL WITH TIMER Key.
User guide
Press the
?
key to view a short description as information window. The
key makes you go back to the previous page.
The key makes you go back to the initial screen.
START
Start cycle.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side .
The soft freezing -18 °C cycle time is displayed in the middle of the screen and
is 1h 30min. by default (always 30 min. for blast chilling and the remaining
time for freezing). Press on the central active area to access the time editing
screen.
The screen for the soft freezing -18 °C time setting will appear. The minimum
value that can be displayed and set is 1h and 30 min., while the maximum
value is 5 h.
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
Press the
START
key to start the soft freezing -18 °C cycle.
During operation the display shows the soft freezing cycle time left (in hours
and minutes) that can be edited by selecting .
You will access the time editing screen which is the same described above.
During blast chilling phase you can decrease the time up to a minimum value
equal to the time of the same.
AUTOMATIC
WITH CORE
PROBE
TIMED
MANUAL
+3°C
?
START
1h:30
3h:30
SAVE
- +
+
+3°C
?
START
1h:30