irinox Freddy 60 - STORAGE Cycle

34 Freddy
MAINTENANCE cycle
Select COLD FUNCTIONS.
COLD
FUNCTIONS
THE MAINTENANCE cycle has been selected.
User guide
Press the
?
key to view a short description as information window. The
key makes you go back to the previous page.
The key makes you go back to the initial screen.
START
Start cycle.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side .
The default storage temperature +3 °C is shown in the middle (air
temperature can be edited during storage phase). Press on the central active
area to access the storage air temperature editing screen.
The storage air temperature setting screen will appear (the temperature
range can be set between -20 °C and +20 °C).
To edit the temperature press the
+
-
keys to increase or decrease the
temperature by 1 °C. If you wish to increase or decrease the temperature in a
faster manner, use the horizontal dragging.
Press the
SAVE
key to conrm the temperature modication, while press
to go back to the previous screen without saving any change.
Press the
START
key to start the cycle. During the customised storage phase,
the time elapsed from cycle start is displayed (cycle duration time). The
temperature inside the chamber detected by the air probe is shown at the
top right-hand side
.
Press on the central active area to view the temperature inside the chamber
detected by the air probe of the customised storage cycle.
Press on the central active area again that shows the temperature inside the
chamber detected by the air probe to go back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial cold functions screen.
+3°C
?
START
3°C
?
0:15:28
+25°C
STOP
?
+3°C
+25°C
STOP
3°C
SAVE
- +
+