Freddy 29
At the end of the cycle, the appliance emits a sound signal that is repeated
again after 3 minutes. At the end of the soft freezing cycle with core probe,
the following will appear ashing slowly. This is to indicate that FREDDY
has set automatically to the storage phase (-20 °C) that can last up to 48 h.
During this phase a sound signal is emitted every 12 h to indicate the
appliance operating status, until reaching the maximum time.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side . Press the key to stop the cycle and go back to
the initial screen.
After 48 h the appliance nishes the cycle in progress and emits three sound
signals. The display shows the message "maximum time elapsed".
By pressing in the "maximum time elapsed" information window you will
go back to the main screen.
+3°C
?
+
MAXIMUM
TIME ELAPSED
CLEANING THE CELL
COLD
FUNCTIONS
HOT
FUNCTIONS
To Next Page
Loading...
