irinox Freddy 60 - Page 50

50 Freddy
Press to access the time editing screen to set the time you wish the
dough to be risen.
The delay time setting screen, i.e. the time you wish the food to be risen, will
appear. The minimum value that can be displayed and set is zero, while the
maximum value is 48 h, including rising cycle (by changing the time, the
initial cold storage phase (+5 °C) time is increased before rising phase).
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
Press the
START
key to start the cycle.
During the cycle in progress, until rising phase has not started, the time left
(countdown) of the cold storage (+5 °C) will be displayed.
This time can be edited by pressing
.
The screen to change the time you wish the food to be ready will appear;
this screen acts on the cold storage (+5 °C) time, as the rising phase has not
started yet.
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
The chamber temperature detected by the air probe is shown at the top
right-hand side of the display.
Press on the central active area to view the time your dough will be ready (i.e.
rising phase end). This value is a read only value and is updated when it is
edited in the previous screens.
Press again on the central active area to view the food ready time and go
back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen.
13:15
SAVE
- +
+
+3°C
?
START
13:152h:00 26°C
?
0:22:25
+3°C
STOP
13:15
SAVE
- +
+
?
0:22:25
+3°C
STOP
?
13:15
+3°C
STOP