TM3160F,TM3200F&TM3240F
36
Stopping Tractor
FIG. 35: To stop the tractor with a hydrostatic trans-
mission, release the forward HST pedal.
This action will stop forward travel. Move the throttle
lever (1) forward to reduce engine speed, depress the
brake pedal (2) and set the parking brake lever (3). Move
the range shift lever (4) to neutral position.
Allow the engine to idle several minutes to allow even
cooling, then turn the main switch to the “off” position,
shutting off the engine.
Lower the three-point hitch and remove the key from
the main switch.
CAUTION: Make sure brakes are adjusted
evenly.
CRUISE CONTROL (TM3240 Hydrostatic Transmis-
sion)
FIGS. 36 & 37: Setting cruise control, cruise con-
trol lever, 2. To set the cruise control, depress the hydro-
static control pedal, 1, forward until the desired speed is
achieved. Move the cruise control lever, 2, rearward to
lock position.
Releasing cruise control, cruise control is released by
depressing the brake pedal, 3, or moving the cruise con-
trol lever, 2, forward to unlock position.
WARNING: Cruise control should only be
used in open spaces, without obstacles, with
unobstructed view or traveling on road. You
must also be thoroughly familiar with releas-
ing cruise control.
NOTE: Do not use cruise control in reverse direction.
FIG. 35
FIG. 36
FIG. 37
To Next Page
