Iseki TM3240 - Air-Bleeding Procedure

TM3160F,TM3200F&TM3240F
62
FIG. 89: To replace the fuel filter element or clean
sediment, turn the fuel valve to the OFF position (top).
Carefully loosen the spanner nut (1) and remove the
nut, sediment bowl (2) and "O"-ring (3). Sediment bowl
can be cleaned at this time. Pull downward on the filter
element (4) and discard. Examine the small "O"-ring (5) in
the filter head and replace as necessary. Install new ele-
ment, pushing upward until seated.
Install sediment bowl "O"-ring and nut. Tighten the nut
and wipe up spilled fuel.
Air-bleeding Procedure
Fuel system should be bled of air after following
cases.
• Emptied fuel tank
• Removal of the fuel filter or fuel piping
FIG. 90 & 91 (TM3160) :
1. Fill the fuel tank.
2. Turn the fuel cock (1) to "ON."
3. Loosen the air-bleeding screw (2) and let air bub-
bles out.
4. Loosen the air-bleeding screw (3) of the fuel injec-
tion pump and let air bubbles out of the pump.
FIG. 90
FIG. 91
FIG. 89