LUBRICATION & PERIODIC MAINTENANCE
71
Rear Wheel Spacing
To reverse the entire wheel and tyre assembly-Raise
both rear tyres of the tractor. Remove the bolts securing
both rear wheel assemblies to the rear axle hubs and
switch wheel assemblies to opposite sides of the tractor.
FIG. 108: Tyre Tread Widths
CAUTION: Rear wheels are heavy. Use care
when moving them. Make sure the tractor is
blocked securely. Tighten all wheel bolts
securely and recheck after short period of
operation.
NOTE: Agricultural lug-tyre tyres must always be
installed so when viewed from the rear, the "V"
pattern of the tread points upward.
Steering Free-Play
FIG. 109: Steering system should be checked for
excessive looseness as indicated by steering wheel free-
play. Maximum free-play is approximately 30 to 60 mm
(1-1/4" to 2-3/8") when measured at the outside of steer-
ing wheel rim as shown at "X". Excessive free-play can
be caused by:
• Loose or worn ball joints
• Worn or damaged steering column shaft / universal
joints
• Worn or damaged power steering unit (if equipped)
CAUTION: Excessive steering free-play must
be corrected before use. Contact your ISEKI
dealer.
AGRICULTURAL TURF
A B C
TM3160 790 mm 962 mm 870 mm
TM3200 820 mm 930 mm 920 mm
TM3240 820 mm 940 mm 910 mm
FIG. 108
FIG. 109
To Next Page
