LUBRICATION & PERIODIC MAINTENANCE
63
FIG. 92 (TM3200 & TM3240):
1. Fill the fuel tank.
2. Turn the fuel cock (1) to "ON."
3. Turn the starter switch to the "ON" O position. Hold
the key in this position for about 10 to 15 seconds,
and the fuel system is bled automatically.
NOTE: Normally, further air-bleeding is not required due
to electric fuel pump operating when starter
switch in instrument panel is ON. If engine will
not start after several attempts, check fuel pump
fuses (see Electrical System) and then proceed
as necessary.
CAUTION: Fuel emitted from loosened injec-
tion lines is under high pressure. Keep hands
and face away when the engine is cranked.
Clean all spilled fuel following air-bleeding
procedure (s).
Throttle Lever
FIG. 93: The throttle lever should remain in the posi-
tion selected by the operator. Through normal use, fric-
tion against the lever may decrease, causing the lever to
move out of the selected position. Turn the adjusting nut
(1) as required to retain the throttle lever in the position
selected.
NOTE: Throttle lever friction adjustment nut is reached
by removing the steering column cover, and
instrument panel.
FIG. 92
FIG. 93
To Next Page
