ISHIDA Uni-3 - 4.4 PRESET KEY REGISTRATION

Chapter 4: PROGRAM MODE
4-14 UNI-3 User’s Manual
4.4 PRESET KEY REGISTRATION
1.
Ensure that the “Program Mode” display is
appearing.
2.
Press [↓] repeatedly to call up the “Preset Key”
display.
● ● ●
Press [ENTER] to call up the lower level menu.
3.
The “Preset Key Registration” display appears.
Press a desired key to register the function.
4.
Enter a desired function number and press
[PLU] to set the function.
5.
If the function is including PLU data to select,
enter the desired data number. Others, enter [0]
6.
Press the desired key again. Then, the preset
key has been registered.