#11
www.istorage-uk.com
iStorage datAshur SD
®
User Manual v1.0.8
Note: When the datAshur SD is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle State (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle State. To access the drive contents
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
9. How to delete the User PIN Policy
1. In Admin Mode, press and hold down both
KEY ( ) + 7 buttons
Solid BLUE LED will change to blinking GREEN
and BLUE LEDs
2. Enter 080 and press SHIFT ( ) button once
Blinking GREEN and BLUE LEDs will change to
a solid GREEN LED and finally to a solid BLUE
LED indicating the User PIN Policy has been
successfully deleted
To delete the User PIN Policy, first enter the Admin Mode as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
Note: When the datAshur SD is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle State (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle State. To access the drive contents
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
To Next Page
Loading...
