#30
iStorage datAshur SD
®
User Manual v1.0.8
www.istorage-uk.com
1. In Admin Mode, press and hold down both
‘KEY ( ) + 8’ buttons.
Solid BLUE LED will change to blinking GREEN
and BLUE LEDs
2. Enter ‘11’ and press the ‘SHIFT ( )’ button once.
GREEN and BLUE LEDs will change to a solid
GREEN LED and then to a solid BLUE LED
indicating the datAshur SD has been set to
enable KeyWriter cloning
The datAshur SD can be used in conjunction with the iStorage KeyWriter application to enable cloning of up to 9 devices at
a time. To set the datAshur SD to enable KeyWriter cloning, first enter the Admin Mode as described in section 5. Once the
datAshur SD is in Admin Mode (solid BLUE LED) proceed with the following steps.
Note: The datAshur SD is set as default to enable KeyWriter cloning.
39. How to set your datAshur SD to enable KeyWriter cloning
40. How to disable KeyWriter cloning
To disable KeyWriter cloning, first enter the Admin Mode as described in section 5. Once the datAshur SD is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
‘KEY ( ) + 8’ buttons.
Solid BLUE LED will change to blinking GREEN
and BLUE LEDs
2. Enter ‘44’ and press the ‘SHIFT ( )’ button once.
GREEN and BLUE LEDs will change to a solid
GREEN LED and then to a solid BLUE LED
indicating the KeyWriter cloning feature has
been disabled
Note: When the datAshur SD is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle State (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle State. To access the drive contents
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
Note: When the datAshur SD is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle State (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle State. To access the drive contents
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
To Next Page
Loading...
