#15
www.istorage-uk.com
iStorage datAshur SD
®
User Manual v1.0.8
14. How to unlock datAshur SD with User PIN
1. In a standby state (solid RED LED) Press and hold
down both the SHIFT ( ) + KEY ( ) buttons
RED LED switches to all LEDs, RED, GREEN &
BLUE blinking on and off
2. Enter User PIN and press the KEY ( ) button
RED, GREEN and BLUE blinking LEDs will
switch to a solid GREEN LED indicating drive
was successfully unlocked in User Mode
15. Changing the User PIN in User Mode
1. In User Mode press and hold down
both KEY ( ) + 4
Solid GREEN LED will change to a blinking
GREEN LED and a solid BLUE LED
2. Enter New User PIN and press the KEY ( )
button
Blinking GREEN and solid BLUE LEDs will
switch to a single GREEN LED blink and then
back to blinking GREEN and solid BLUE LEDs
3. Re-enter New User PIN and press the KEY ( )
button
GREEN LED will rapidly blink three times and
will then change to a solid GREEN LED
indicating a successful User PIN change
To change the User PIN, first unlock the datAshur SD with a User PIN as described in section 14. Once the drive is in User
Mode (solid GREEN LED) proceed with the following steps.
Important: Changing the User PIN must comply with the ‘User PIN Policy’ if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a ‘Special Character’ has to be
used. The administrator can refer to section 10 to check the user PIN restrictions.
Note: When the datAshur SD is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle State (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle State. To access the drive contents
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
To unlock with the User PIN, the datAshur SD must first be in Standby State (solid RED LED) by pressing and holding down
the SHIFT ( ) button for one second.
To Next Page
Loading...
