Digital Network Public Address & Voice Alarm System
set up only under the "adjacent layer model", in the pointed partition mode, will not be able to configure)
Step 3: click "the partition power amplifier 1"in the child nodes of the "partition power amplifier &
changeover machine" list box, on the right of configuration box, will list the contact trigger detailed
configuration information box of "amplifier 1 partition" (if you need to configure the contact of other
partition amplifier & changeover machine, select the other devices that you want to configure)
Step 4: click [...]Sub menu button on the right of "partition control" list box, it will pop up "partition editor"
configuration list box.(only "alarm rules" is set under the pointed partition, it can choose the zone control,
if under the "adjacent layer model", the zone control is unable to choose)
Step 5: selecting when online trigger, which partition will link to perform.( For the configuration details of "
partition editor ", refer to" partition configuration" to select)
Step 6: selecting when online trigger, which audio source the partition broadcast will link to play.
Step 7: selecting the music playback mode.
Step 8: selecting the song to play.
Step 9: configuring when online trigger output of host, the DC 24V output interface on the rear panel of
To Next Page
Loading...
Need help?
General
