Digital Network Public Address & Voice Alarm System
The right detection way:
1. Firstly, press [RESET/OFF] button on VA-6000MA to top the system buzzer.
2. Secondly, connect VA-6000RM and VA-6000MA with a proper cable.
3. If the equipments are normally connected, the system will automatically restore to its previous working
state. The buzzer of VA-6000RM and VA-6000MA will stop ringing. The system state indicator will turn to
green light flashing.
7.PC software instructions
System configuration including MAC address order allocation, zone name, devices name and group
configuration.
7.1.1.Equipment areas specified
Description:
The configured MAC address table will be saved in the host VA–6000MA, only the designated MAC
address of zone amplifier VA-P8500S or changeover VA-6000MS can be controlled.
Every MAC address in zone amplifier VA-P8500S and changeover VA-6000MS MAC address list would
be directly map onto physical zones start address, such as: configure one MAC address of zone amplifier
VA-P8500S, then the module starting physical zone is 1; configure two MAC addresses, the second
module starting physical zone is 2, and so on. For whole system zone amplifier, the maximum zone
configuration number is 7; For changeover amplifier VA-6000MS MAC address, the module starting
physical zone is 1, if configured two MAC addresses, then the second module starting physical zone is 9,
and so on, the maximum number of whole system the changeover amplifier is 64, the host MAC address
table does not participate in distribution of the physical zones.
Step 1: login the main interface of the software and click on the menu bar: Operation → equipment
position setting, "equipment area designation" regional Settings dialog box will pop up.
To Next Page
Loading...