Technical Specification
1. Internal absorption current and internal absorption power mean the
absorption current and power of the standard power dissipater inside the power
supply.
2. Resistance programming accuracy differs based on different output current.
For example, 10A Transient 1.0Ω, accuracy: (1.0Ω * 0.25%) +(375mΩ*A /10A)
= 40mΩ.1.0Ω, accuracy: (1.0Ω * 0.25%) +(375mΩ*A /10A) = 40mΩ.
3. Set value accuracy means the set accuracy realized through the panel button
or communication instructions. When external analog is used for programming,
the programming accuracy is 2%FS.
4. Read-back value accuracy means the read-back accuracy realized through
panel display or communication instructions; when external analog is used for
monitoring, the monitoring accuracy is 1%FS.
5. Up time and down time mean the time of establishment from one value to
another value under ON status when the internal standard power dissipater is
enabled.
6. Use 12V/120AH battery for test.
7. When used in parallel, to balance power of each phase, distribute the
instrument to three phases. But must ensure that single machine input voltage
meets Specification requirements.
8. It means the maximum phase current value under minimum work input
voltage.
5.1.17 IT6527C
Parameter IT6527C Ver:V1.6
Output Rating ( 0 ℃-40
℃)
Output Voltage
0～1000V
Output Current
0～10A
Internal Sink
Current
1
0～1.5A
Output Power
0～3000W
Internal Sink
Power
1
0～50W
Output Resistance
Range
0～333.333Ω
Accuracy
2
0.25%+375mΩ*A
Resolution 10mΩ
Line regulation
±(％of Output+Offset)
Voltage
≤0.01%+100mV
Current ≤0.01%+5mA
Copyright © Itech Electronic Co., Ltd.
136
To Next Page
Loading...
Need help?
General
