Quick Reference
No. Name Description
11 System bus Used for communication between instruments in
parallel operation
12 Analog interface
and CAN interface
Analog interface and CAN interface
2.7 Power-on Selftest
A successful selftest indicates that the purchased power product meets delivery
standards and is available for normal usage.
Before operation, please confirm that you have fully understood the safety
instructions.
• To avoid burning out, be sure to confirm that power voltage
matches with supply voltage.
• The system bus interface is not isolated from the output
electrode. After power on, it is not allowed to insert or pull out
the bus and terminal matching resistance.
Power Switch Introduction
User can adjust the power switch directly to turn on or turn off the instrument.
The status of Power switch is as follows.
On Off On Off
If the instrument is the cabinet type, the rear panel of the cabinet provides a
master power switch. The relationships between the device status and switch
status are listed in the following table.
Copyright © Itech Electronic Co., Ltd.
16
To Next Page
Loading...
Need help?
General
