Inspection and Installation
You can select different interfaces by clicking the seven buttons shown in the
navigation bar on the left side of the window. The detailed descriptions are as
follows.
• Home: Http home interface, displays the model and appearance of the
instrument.
• Information: Displays the serial number of the instrument and more system
information as well as LAN configuration parameters.
• Web Control: Enables the Web control to begin controlling the instrument.
This page allows you to monitor and control the instrument.
• LAN Configuration: Reconfigure the LAN parameters.
• Security: Change the password and control access to the Http interface.
• Manual: Go to the ITECH official website and view or download the relevant
documents.
• Logout: Logout the Http interface.
2.6.2.2 Using Telnet
The Telnet utility (as well as sockets), is another way to communicate with the
instrument without using I/O libraries or drivers. In all cases, you must first es-
tablish a LAN connection from your computer to the instrument as previously
described.
In an MS-DOS Command Prompt box, type “telnet hostname” where hostname
is the instrument’s IP address. Press the Enter key and you should get a Telnet
session box with a title indicating that you are connected to the instrument and
23 is the instrument’s telnet port. Type the SCPI commands at the prompt.
Copyright © Itech Electronic Co., Ltd.
26
To Next Page
Loading...
Need help?
General
