Operation and Application
4.10 System-Related Operations
4.10.1 Switch Local/Remote Mode
IT7200 series power source provide local operation and remote operation. The
default mode is local operation mode.
• Local operation mode: use front panel keys to control the power source.
• Remote operation mode: the power source is connected to PC, the user
uses the software in PC to control the power source remotely. During remote
control operation, the[Enter] key on the front panel is lit. All panel keys, ex-
cept the [On/Off] and [Local] keys, are locked (If a protection state occurs,
the [Esc]key can still be used to clear the protection). You can press[Local]
to switch the remote control to local control. The mode modification will not
affect the output parameters.
4.10.2 Save and Recall Operations
IT7200 series power source can save up to 10 common parameters in nonvola-
tile memory (No. 0 to No. 9) for user to recall conveniently. The contents stored
in each group include: output mode(AC/DC), voltage setting value(AC), voltage
setting value(DC), OCPrms, frequency setting value and phase angle.
Save Operations
1. Press the composite keys[Shift]+ [4] (Save) to enter the parameter save
interface.
110.0V 1.00A 60.0Hz
Save data bank = 0
Information description:
• The first line displays the content to be saved, i.e., the real-time setting
value.
• The second line displays the setting value of the saved position.
2. Rotate the knob and input the digits 0~9 to set the saved position.
3. Press the [Enter] key to save the real-time setting value.
Recall Operations
1. Press the composite keys [Shift]+ [1](Recall) to enter the parameter recall
interface.
5.00V 6.00A DC MODE
Recall data bank =3
Information description:
Copyright © Itech Electronic Co., Ltd.
61
To Next Page
Loading...
Need help?
General
