ITech IT7200 Series - 4 Operation and Application; Select the Output Mode

Operation and Application
4 Operation and Application
This chapter describes the operation and application of the instrument in
details.
♦ Select the Output Mode
♦ Set the AC Output
♦ Set the DC Output
♦ Set the Over-current Protection Point
♦ Turning the Output On and Off
♦ Step or Continue Output
♦ Executing Measurement
♦ Function Operation
♦ Protection Function
♦ System-Related Operations
4.1 Select the Output Mode
The IT7200 series power supply has 3 output modes: AC, DC and AC+DC. The
User should set specific output mode based on required applications.
AC Mode
This mode is the default mode when the instrument is powered on (It is neces-
sary to press [Shift]+[3] (AC) key to switch the DC mode back to the AC mode),
indicating that the instrument is used as AC power supply. Under this mode, the
instrument will generate AC output.
Please refer to 4.2 Set the AC Output for the setting of related output parame-
ters of the instrument under AC mode.
DC Mode
Press [Shift]+[6] (DC) key on the front panel to switch the instrument from AC
mode to DC mode. At this moment, the instrument serves as a DC power sup-
ply. Under this mode, the instrument will generate DC output.
Please refer to 4.3 Set the DC Output for the setting of related output parame-
ters of the instrument under DC mode.
Copyright © Itech Electronic Co., Ltd.
34