Getting Started
Press [On/Off] key to enable the instrument output. When the Output is in
On status, the Output [On/Off] key will light up; when the Output is in Off sta-
tus, the Output [On/Off] will light off.
8. Check the Meter value of the instrument.
After the output is enabled, the instrument will continuously measure and
display the Meter values of Vrms, Irms, Freq, Ip, PF, Q, P, S, vTHD, and
iTHD on the front panel.
10.03V 0.0005A 50.0Hz
0.00W 0.0056Ip 1.00PF
Press the [Select] key to switch the display of Meter value.
10.03V 0.0005A Q= 0.0
0.00W 0.0VA vTHD=1.02
Copyright © Itech Electronic Co., Ltd.
33
To Next Page
Loading...
Need help?
General
