SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 88
[SOURce:]RESistance:VDRop
This command is used to set the CR mode and the LED Cut-off voltage value
when the LED test function is enabled.
Command Syntax
[SOURce:]RESistance:VDRop <NRf+>
Parameters
0 through MAX | MINimum | MAXimum | DEFault
Unit
V (volts)
*RST Value
MINimum
Examples
RES:VDR 5
Query Syntax
[SOURce:]RESistance:VDRop? [ MINimum | MAXimum | DEFault ]
Returned Parameters
<NR3>
Related Commands
VOLT:VDR
[SOURce:]RESistance:LED[:STATe]
This command enables or disenables the LED test option in CR mode.
Command Syntax
[SOURce:]VOLTage:LED[:STATe] <b>
Parameters
0 | 1 | ON | OFF
*RST Value
ON
To Next Page
Loading...
