ITech IT8731

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 95
Examples
IMP 5 IMP:LEV 3.5
Query Syntax
[SOURce:]IMPedance[:LEVel][:IMMediate]? [ MINimum | MAXimum | DEFault ]
Returned Parameters
<NR3>
Related Commands
IMP:RANG
[SOURce:]IMPedance:RANGe
This command is used to set the resistance range when the load is in CZ mode.
Command Syntax
[SOURce:]IMPedance:RANGe <NRf+>
Parameters
MINimum through MAX | MINimum | MAXimum | DEFault
Unit
R(ohms)
Returned Parameters
MAXimum (high range)
Examples
IMP:RANG 15 SOUR:IMP:RANGE MIN
Query Syntax
[SOURce:]IMPedance:RANGe? [ MINimum | MAXimum | DEFault ]
Returned Parameters
<NR3>
[SOURce:]IMPedance:RESistance
This command is used to set the resistance value series to the capacitance
when the load is in CZ mode.