ITech IT8731

List Commands
Copyright © Itech Electronic Co., Ltd. 101
Command Syntax
[SOURce:]LIST:LEVel <NR1>, <NRf>
Parameters
1 to steps, MIN to MAX
Unit
NONE, NONE
Examples
LIST:LEV 1, 10 LIST:LEV 2, 15.2
Query Syntax
[SOURce:]LIST:LEVel? <NR1>
Returned Parameters
<NR3>
Related Commands
LIST:RANG
[SOURce:]LIST:SLEW
This command sets the slew rate for each step. This command programs both
positive and negative going slew rates. MAXimum sets the slew to its fastest
possible rate. MINimum sets the slew to its slowest rate. LIST:SLEW? returns
the number of points programmed.
Command Syntax
[SOURce:]LIST:SLEW[:BOTH] <NR1> ,<NRf>
Parameters
1 to steps, MIN to MAX
Unit
NONE, NONE
Examples
LIST:SLEW 1, 1.5
LIST:SLEW 2, MAX