SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 94
Related Commands
POW:PROT
[SOURce:]POWer:TRIGgered
This command is used to set the on-load power value when the next trigger
occurs.
Command Syntax
[SOURce:]POWer[:LEVel]:TRIGgered[:AMPLitude] <NRf+>
Parameters
MINimum through MAX | MINimum | MAXimum | DEFault
Unit
W (power)
Returned Parameters
MAXimum
Examples
POW:TRIG 120 POW:LEV:TRIG 150
Related Commands
POW
[SOURce:]IMPedance
This command sets the resistance value in CZ mode.
Command Syntax
[SOURce:]IMPedance[:LEVel][:IMMediate] <NRf+>
Parameters
MINimum through MAX | MINimum | MAXimum | DEFault
Unit
R(ohms)
Returned Parameters
MAXimum
To Next Page
Loading...
