Function and Features
Copyright © ITECH Electronic Co., Ltd. 50
15. Press ESC key to exit editing menu.
The above steps only set entire framework of auto tests. Additional
setting is required for specific parameters in each step. This design will
facilitate modification of parameters in a single step.
16. Select required working mode. Set working
voltage/current/power/resistance. Press [Shift] + [CV] to enter parameter
setting.
10.0000V 0.0000A
0.00W CC=1.000A
17. It is assumed that step 1 edits CC mode as follows: current: 2A, maximum
voltage value: 10V, and minimum voltage value: 2V; and step 2 edits CV
mode as follows: voltage: 3V, maximum current value: 5A, and minimum
current value: 0A. After parameter setting in each step, press [Esc] to exit
menu setting. And press [Shift] + 4 for saving. Setting at each step should
be saved. The saving position is same as that of step number. Settings at
each step should be independently saved. Refer to the
“Correspondence Table for Auto Test Files and Single-Step Parameter
Saving Positions”.
18. It is necessary to recall test files for running after editing auto test files.
Recall test file for running
To recall edited test files from EEPROM quickly after re-energizing instrument,
refer to the method below.
1. Press [Shift] + 2.
PROGRAM
Run Recall Edit
2. Move Left/Right Key and select [Recall] key. Press [Enter] key for
confirmation.
RECALL PROGRAM
Recall Program File=1
3. Move Left/Right Key and select Run. Press [Enter] key for confirmation.
PROGRAM
Run Recall Edit
4. Display auto test file 1.
PRG01 STOP
5. Press [Trig] key.
Operate auto test file 1. Press [Pause] key on board to pause auto test.
Press Move key for next step.
To Next Page
Loading...
