16
Pager Messages
When an event is reported on a numeric pager, the fol-
lowing information is included:
Although all three types of information can be reported
on your pager, your pager service determines how the
information will actually appear.
Event Code in Page
This part of the page let’s you know what has happened.
Sensor Number or User Number in Page
This part of the page let’s you know who or what is caus-
ing the event.
Account Number in Page
This part of the page let’s you know where (which parti-
tion) the event is occurring.
Streamlining the Page Report
You can choose to have the four account number digits
reported with every page, or to exclude them. Each parti-
tion has its own account number, so seeing the digits is
useful if multiple partitions are reporting to one pager.
Ask your dealer or installer if you would like the Stream-
line feature turned on.
Sample pager
message with the
Streamline feature
turned on:
Pager Event Codes
Code Indicates
009 A sensor has been restored to its non-
alarm state
111 System has been disarmed
115 Sensor test exit
118 System trouble has been fixed
119 System alarm condition has been can-
celled
222 System armed to Level 2—STAY
333 System armed to Level 3—AWAY
555 System phone/sensor test
888 System has a trouble condition
999 System is in alarm condition
Note: If a user arms the system to level 3 (AWAY)
the pager will report that the system was
armed to level 3 (333). However, if the Auto
Stay Arming feature is enabled and the user
does not exit the premises, the arming level
will revert to level 2 (STAY) without notifying
the pager. Refer to the User Sheets in Appen-
dix A to see whether this feature is on or off.
Sensor num ber or user num ber
Event code L a s t fo u r d ig its o f c e n tra l
station account num ber
Pager Sensor/User Numbers
Code Indicates
000 System event not caused by a sen-
sor or user
001 — 076 Sensor numbers 1 through 76
600 — 659 User codes 00 through 59 used
678 System Master code used
679 Installer code used
680 Dealer code used
697 Quick Arm used
698 Keyswitch sensor used
699 System armed itself because it is
being serviced or powered-up
Code Indicates
XXXX 4-digits of account number
Sensor num ber or user num be
Event code
To Next Page
