20
S
ECTION
14:
S
CHEDULED
A
RMING
The Scheduled Arming feature allows the panel to be
armed to Level 3—AWAY according to a schedule. When
an active schedule start time is reached the panel will exit
User Programming, automatically bypass any open sen-
sors, and arm to Level 3—AWAY.
The panel will not arm according to an active schedule if
the start time is reached while:
• The panel is already armed to Level 3—AWAY.
• The panel is performing a phone or sensor test.
Note: The panel cannot be disarmed by schedules.
To schedule arming:
1. At an alphanumeric or fixed display touchpad,
enter the programming menus by pressing
9
+ System or Partition Master
CODE
.
2. Press
0660
+
ƒ
.
3. The touchpad displays “AWAY.”
4. Press
ƒ
. The touchpad displays the first available
time schedule as “SCHEDULE 00 OFF,” or “SCH
00 OFF.”
5. Enter
•
2
+
ƒ
to assign the time schedule (“ON”) to
arm the panel.
•
1
+
ƒ
to make the time schedule inactive.
6. Press
B
to go to the next time schedule, if
needed, and turn the schedule on or off for arming
to AWAY.
7. When you’ve finished attaching the desired time
schedules, press
‚
+
00
+
ƒ
to exit the
programming menus.
S
ECTION
15:
O
PENING
AND
C
LOSING
R
EPORTS
The Opening and Closing Reports feature allows pager-
holders and/or the central station to be notified whenever
the system is armed and/or disarmed.
When Will this Feature Be Active?
The Opening and Closing Reports feature can be enabled
only by the installer. There is nothing more that the user
needs to program in order to receive the Opening and/or
Closing pages.
If a pagerholder no longer wishes to receive the reports,
the pagerholder needs to contact the installer to turn off
this option for that pager.
Opening and Closing Reports occur without regard to
any time schedule. There are no special codes that the
user needs to enter in order for the page to be sent.
Who Will Be Paged?
Your system can call up to 5 different pager numbers, as
well as the central station, to report an Opening and/or
Closing Report.
Refer to “Appendix A: User Sheets” on page 37 to see
which pagers have been set up to receive a page for this
feature. Contact the installer if you would like to turn
Opening and Closing Reports on or off for any pro-
grammed pager or for the central station.
What Will the Pager Report?
For Opening Reports, the page reports the arming level
(111 for 1—OFF) and the user.
For Closing Reports, the page reports the arming level as
222 (2—STAY) or 333 (3—AWAY), and the user that armed
to that level. See “Pager Event Codes” on page 16 for
more information.
To Next Page
