Notices
FCC Notices
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Install a quality radio or television outdoor antenna if the indoor antenna is not adequate.
• Reorient or relocate the panel.
• Move the panel away from the affected equipment.
• Move the panel away from any wire runs to the affected equipment.
• Connect the affected equipment and the panel to separate outlets, on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
• Send for the FCC booklet How to Identify and Resolve Radio-TV Interference Problems, available from the U.S. Government Printing Office, Washington, D.C.
20402. Stock Number: 004-000-00345-4.
Changes or modifications not expressly approved by Interactive Technologies, Inc. can void the user’s authority to operate the equipment.
This equipment complies with part 68 of the FCC rules. On the FCC label affixed to this equipment is the FCC Registration Number and Ringer Equivalence Number
(REN) for this equipment. If requested, provide this information to your telephone company.
The REN is used to calculate the maximum number of devices your telephone line will support with ringing service. In most areas the sum of all device RENs should
not exceed 5.0. Contact your local telephone company to determine the maximum REN for your calling area.
If your telephone equipment causes harm to the telephone network, your telephone company may temporarily disconnect your service. If possible, you will be noti-
fied in advance. When advance notice is not practical, you will be notified as soon as possible. You will also be advised of your right to file a complaint with the
FCC.
Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the proper operation of your equipment. You
will be given advanced notice in order to maintain uninterrupted service. The telephone company may ask you to disconnect this equipment from the network until
the problem has been corrected or until you are sure that the equipment is not malfunctioning. This equipment may not be used on coin service provided by the tele-
phone company. Connection to party lines is subject to state tariffs.
Declaration of Conformity (DoC)
Interactive Technologies, Inc. declares that the ITI model no. 60-792-95R is in conformity with Part 15 of the FCC Rules. Operation of this product is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Canada Notice
The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications
network protective, operational, and safety requirements. The department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single-line individual service may be
extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
For your protection, make sure that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe system, if present, are
connected together.
Caution
Do not attempt to make connections yourself. Contact the appropriate electrician or electric inspections authority.
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop that is used by the device to
prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the LNs of all the devices
does not exceed 100. Load Number: 0.2B AC.
“AVIS: - L
étiquette du ministère des Communications du Canada identifie le matériel homologué. Cette étiquette certifie que le matériel est conforme a certaines
normes de protection, d´exploitation et de sécurité des réseaux de télécommunications. Le ministère n´assure toutefois pas que le matériel fonctionnera a la satis-
faction de l´utilisateur.
Avant d´installer ce matériel, l´utilisateur doit s´assurer qu´il est permis de le raccorder aux installations de l´enterprise locale de télécommunication. Le matériel
doit également etre installé en suivant une méthod acceptée de raccordement. Dans certains cas, les fils intérieurs de l´enterprise utilisés pour un service individuel
a ligne unique peuvent etre prolongés au moyen d´un dispositif homologué de raccordement (cordon prolongateur téléphonique interne). L´abonné ne doit pas
oublier qu´il est possible que la conformité aux conditions énoncées ci-dessus n´empechent pas le dégradation du service dans certaines situations. Actuellement,
les enterprises de télécommunication ne permettent pas que l´on raccorde leur matériel a des jacks d´abonné, sauf dans les cas précis prévus pas les tarrifs particu-
liers de ces enterprises.
Les réparations de matériel homologué doivent etre effectuées pas un centre d´entretien canadien autorisé désigné par le fournisseur. La compagne de télécommu-
nications peut demander a l´utilisateur de débrancher un appareil a la suite de réparations ou de modifications effectuées par l´utilisateur ou a cause de mauvais
fonctionnement.
Pour sa propre protection, l´utilisateur doit s´assurer que tous les fils de mise a la terre de la source d´énergie électrique, des lignes téléphoniques et des canalisa-
tions d´´ eau métalliques, s´ il y en a, sont raccordés ensemble. Cette précaution est particulièrement importante dans les régions rurales.
Avertissment. - L´utilisateur ne doit pas tenter de faire ces raccordements lui-meme; il doit avoir recours a un service d´inspection des installations électriques, ou a
electricien, selon le cas”.
Une note explicative sur les indices de charge (voir 1.6) et leur emploi, a l´intention des utilisateurs du matériel terminal, doit etre incluse dans l´information qui
accompagne le materiel homologué. La note pourrait etre rédigée selon le modèle suivant:
“L´indice de charge (IC) assigné a chaque dispositif terminal indique, pour éviter toute surcharge, le pourcentage de la charge totale qui peut etre raccordée a un cir-
cuit téléphonique bouclé utilisé par ce dispositif. La terminaison du circuit bouclé peut etre constituée de n´import somme des indices de charge de l´ensemble des
dispositifs ne dépasse pas 100.”
L ´ Indice de charge de cet produit est ____________.
Trademarks
ITI is a registered trademark of Interactive Technologies, Inc. Concord, SuperBus, SnapCard, and ToolBox are trademarks of Interactive Technologies, Inc. X-10 is a
registered trademark of X-10 (USA), Inc.
This manual may refer to products that are announced but are not yet available.
To Next Page
