iTriangle Infotech Pvt Ltd
Interface 30 of 43
Note: Engineering Documents are Highly Confidential
7.6.1.3 IRU_REG
This command is used to set the unique client ID in case of different db for different clients.
Format:
set$<Serial Number/IMEI>@<Password>#IRU_REG:<Client ID>*
<Client_ID>: It is unique id given to the client.
Example:
set$141214426@aquila123#IRU_REG:CLIENT_1DU*
7.6.1.4 CFG_GSM
This command is used to configure Admin 1 & Admin 2 Phone numbers for device status replies in
case of firmware updates.
Syntax:
set$<Serial Number/IMEI>@<Password>#CFG_GSM:<Admin1>,<Admin 2>,TEXT*
<Admin1 Phone Number>: Admin phone number [10 digits] to which fixed message are delivered.
<Admin2 Phone Number>: Admin phone number [10 digits] to which fixed message are delivered.
<Mode>: It may be Text or PDU [Packet Data Unit]. Please use TEXT by default.
Example:
set$141214426@aquila123#CFG_GSM:8884007979,9901935194,TEXT*
7.6.1.5 CHG_TOF
This command is used to configure TOF [GMT Offset] Country specific Offset setting. By default, the
value will be zero.
Format:
set$<Serial Number/IMEI>@<Password>#CHG_TOF:<Time Zone Offset in seconds>*
Example:
set$141214426@aquila123#CHG_TOF:19800*
7.6.1.6 CFG_OS
This command is used to set the over speed threshold and de-bounce interval for generating the
over-speed event.
Syntax:
set$<Serial Number/IMEI>@<Password>#CFG_OS:<over speed cut-off value>,<Duration in
seconds>S*
<Over speed cut-off Value>: Over speed cut-off value.
<Duration in seconds >: Duration in seconds. (Minimum value is 5 sec and max value is 30sec)
Example:
set$141214807@aquila123#CFG_OS:60,30S*
To Next Page
Loading...