iTriangle Infotech Pvt Ltd aQuiLa TS101-Basic - Diagnostic;Status commands; CHKCFG

iTriangle Infotech Pvt Ltd
Interface 32 of 43
Note: Engineering Documents are Highly Confidential
7.6.1.11 CFG_HA
This command is used to enable harsh acceleration event and configure the rata of change of speed
threshold. When the device crosses the threshold, the device will generate an event.
Syntax:
set$<SerialNumber/IMEI>@<Password>#CFG_HA:<1=Enable/0=Disable>,<speed change (KMPH/s)>*
Example:
set$140613238@aquila123#CFG_HA:1,20*
7.6.1.12 CFG_HB
This command is used to enable harsh braking event and configure the rata of change of speed
threshold. When the device crosses the threshold, the device will generate an event.
Syntax:
set$<Serial Number/IMEI>@<Password>#CFG_HB:<1=Enable/0=Disable>,<speed change(KMPH/s)>*
Example:
set$140613238@aquila123#CFG_HB:1,20*
7.6.1.13 CFG_DID
This command is used to select the device ID type in the packets which are sent to the server. User
can configure the device to send either Serial number or IMEI number in the packets.
Syntax:
set$<SerialNumber/IMEI>@<Password>#CFG_DID:<1=IMEI/0=SerialNumber>*
Example:
set$140613238@aquila123#CFG_DID:1*
7.6.1.14 CFG_FP
This command is used to enable or disable the First packet sending feature after every new
connection. This packet will have the configuration and firmware information in it.
Syntax:
set$<SerialNumber/IMEI>@<Password>#CFG_FP:<1=Enable/0=Disable>*
Example:
set$140613238@aquila123#CFG_FP:0*
7.6.2
Diagnostic/Status commands:
The diagnostic commands are used for the getting the current information from the devices when
the devices are deployed in the field.
7.6.2.1 CHKCFG
This command returns the configuration of the device along with the GPS fix status of the device.
Syntax:
%CHKCFG%<Password>
Example: