iTriangle Infotech Pvt Ltd
Interface 34 of 43
Note: Engineering Documents are Highly Confidential
Format of the return message:
http://maps.google.com/maps?q=12.995135,77.525017
7.6.2.4 GETIO
This command is used to get the status of the digital IOs of the device.
Syntax:
%GETIO%<Password>
Example:
%GETIO%aquila123
Response Format:
IGN:<0=Off/1=On>; DI1:<0=Low/1=High>; DI2:<0=Low/1=High>; DO1:<0=Inactive/1=Active>, Case
SW:<0=Closed/1=Open>, Main Power: <0=Disconnected/1=Connected>
Example:
IGN:0; DI1:0; DI2:0; DO1:0, Case SW:0, Main Power: 1
7.6.3 Control Commands:
7.6.3.1 SET_DO1
The below command is used to activate/deactivate the Digital Output
Syntax:
set$<Serial Number>@<Password>#SET_DO1:<0=disable/1=Enable/2=Check
Speed and disable/3=Check Speed and Enable>*
Example:
set$101010119@aquila123#SET_DO1:1*
set$101010119@aquila123#SET_DO1:2*
7.6.3.2 FORCE_MS
The below command is used to “Maintenance Server” It will force to immediately divert the device
to the maintenance server. If the customers are using Private APN from the service providers it is
mandatory to whitelist “ms1.aquilatrack.com”.
Syntax:
FORCE_MS:<password>
Example:
FORCE_MS:aquila123
7.6.3.3 Soft Restart
The below command is used for “Soft Restart”. This will not acknowledge any message, but in device
LED status you can see the changes.
restart:aquila123
To Next Page
Loading...