42
Programming
Mode CASCADE SERIAL/SYNCHRON:
running -> Pump is running
stopped -> Pump is stopped
disabled -> Pump is disabled by an external input.
(Stopped with buttons or disabled with parameter ENABLE DEVICE [24]) or by external
on/off contact open
preparing -> A new unit is connected to the multi-pump system and Data is being transferred
solo run -> Solorun (Hand Mode) is activated (XSL closed)
faulted -> A failure has occurred on the current unit
24
24 ENABLE DEVICE
Enable – Disable of the selected device
Enable
Possible settings: Enable - Disable
Allows the drive to be be enabled or disabled by an external switch between X3 7 and 8. (Either in cas-
cade relay / serial / synchron or controller mode).
25
25 MOTOR HOURS
Runtime of the selected drive
XXXXX h
Total number of hours the motor has run. To reset see parameter CLR MOTORH. [1130].
Error memory
All errors, including those occuring on Basic Inverters are saved on the Master Inverter in this menu. The
errors saved in this menu include the failure message text of the drive where the failure happened, and
the date and time when the failure occurred. (For more information about errors, see chapter 10 failure
messages.)
26
26 1st ERROR
Most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
27
27 2nd ERROR
2nd most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
28
28 3rd ERROR
3rd most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
G
G
G
G
G
S
To Next Page
Loading...
