ITW Dynatec DY 2008 - Service Settings Menus

F1 F2 F3 F4
K 1:C
K2:
K3:
c4:
K5:
KC 6:
K7:
K8:
Pattern
Pressure
System
Compensat.
0 m/min
PRESS1: 20%
PRESS2: 10%
PRESS3: 10%
PRESS4: 10%
Programm: 1
F1 F2 F3 F4
Version: V2.xx
INITIALIZING CHANNEL
Adhesive Application Systems
F1 F2 F3 F4
LANGUAGE
LOAD PROGRAM
CHANNEL : TRIGGER
TRIGGER LOCK
CHANNEL : ENCODER
ENCODER SCALING
MIN/MAX SPEED SET.
CHANNEL MODE
CHANGE SECURITY LOCK
RETURN
0 m/min
1
2
3
4
5
6
7
8
9
--
--
--
--
--
--
--
--
--
SERVICE SETTINGS 1 OF 3
STOP
123
CONTRAST+
CONTRAST-
F1 F2 F3 F4
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
RETURN
0 m/min
1
2
3
4
5
6
7
8
9
--
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
STOP
123
CONTRAST +
CONTRAST-
F1 F2 F3 F4
STOP-CONFIGURATION
PC-COMMUNICATION
PROFIBUS ADDRESS
RESERVE
RESERVE
RESERVE
RESERVE
LOAD FACTORY SETUP
CHANGE SECURITY LOCK
RETURN
0 m/min
1
2
3
4
5
6
7
8
9
--
--
--
--
--
--
--
--
--
SERVICE SETTINGS 3 OF 3
STOP
123
CONTRAST+
CONTRAST-
STOP
Manual #50-14 Revised 8/08
Page 4-- 3
C. 1998
Service Setting Menus
Changing these settings may be neccesary during initial installation or after modification
to the system. After pressing the Stop button, these menus are selectable with the Service
button. The following settings are some of the available selections:
Turn power on to the control unit.
The Main Menu will come up after a few seconds
Press the Stop button,
and then the Service Settings Button.
Service Settings Menu 1 appears.
Select the desired parameter menu with the numeric
keys and procede with programming.
Press the Service Settings key again
Service Settings Menu 2 appears.
Select the desired parameter menu with the numeric
keys and procede with programming.
Press the Service Settings button again
Service Settings Menu 3 appears.
Select the desired parameter menu with the numeric
keys and procede with programming.
Use button F4 to return to the Main menu at any time.