ITW Dynatec DY 2008 - Shutter Trigger Setup

STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
PROFIBUS ADDRESS :
PROFIBUS
STOP
PROFIBUS ADDRESS
2: 0 m/min
3: 0 m/min
4: 0 m/min
3
3
RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
STOP-CONFIGURATION
PC-COMMUNICATION
RESERVE
SHUTTER TRIGGER SET
RESERVE
DIGITAL CONFIG
RESERVE
LOAD FACTORY SETUP
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
SERVICE SETTINGS 3 OF 3
RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
123
Page 4-- 34
Manual #50-14 Revised 8/08
C. 1998
Enter Access Code if this function is
protected.
Press Enter Button.
Enter the desired Profibus Address via the
numeric keypad.
Press Enter Button.
Press F4 to return to previous menu.
Shutter Trigger Setup
Use this menu to select the properties of the dedicated
shutter trigger device (X20) as being either NPN (sink-
ing) or PNP (sourcing).
Press button 4.
Enter Access Code if this function is
protected.
Press the Enter Button after entering the
Access Code.
Press the F3 button to select NPN or PNP.
Press the Enter Button to save the setting to
memory.
STOP1: 0 m/min
SHUTTER DWELL TIME MENU
NPN/PNP
SHUTTER
1
RETURN
SHUTTER TRIGGER SETUP MENU
NPN