STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
STOP-CONFIGURATION
PC-COMMUNICATION
RESERVE
SHUTTER TRIGGER SET
RESERVE
DIGITAL CONFIG
RESERVE
LOAD FACTORY SETUP
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
SERVICE SETTINGS 3 OF 3
RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
1
RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
STOP-CONFIGURATION
PC-COMMUNICATION
RESERVE
SHUTTER TRIGGER SET
RESERVE
DIGITAL CONFIG
RESERVE
LOAD FACTORY SETUP
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
SERVICE SETTINGS 3 OF 3
Page 4-- 32
Manual #50-14 Revised 8/08
C. 1998
Service Settings Menu 3 (of 3) Programming
Assure STOP is active.
Press the Service button until you see the
menu at right.
Use the buttons 1 to 9 to select one of the listed
functions.
STOP--Configuration
This function determines the behavior of the controller in case of a restart after a stop of
the production machine. In most cases a restart will start gluing with the next trigger. Some
special applications require the current glue pattern to be completed before starting with
the next product.
Press button 1.
Enter Access Code if this function is
protected.
Press Enter Button.
Use button F1 or F2 to select a channel.
Use the F2 or F3 button to change the
Stop--function
Press Enter Button.
Press F4 to return to previous menu.
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
STOP CONFIGURATION MENU
STOP CONFIGURATION
CHAN.
1
2
3
4
4: 0 m/min
RETURN
NOT FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
STOP CONFIGURATION MENU
STOP CONFIGURATION
Channel
1
2
3
4
4: 0 m/min
RETURN
FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
NOT FINISH GLUING UPON RESTART
To Next Page
Loading...