ITW Dynatec DY 2008 - Change Security Lock

RETURN
ACCESS CODE: ----
STOP
1: 0
m
/min
CONTRAST+
CONTRAST--
RETURN
LANGUAGE
LOAD PROGRAM
CHANNEL : TRIGGER
TRIGGER LOCK
CHANNEL : ENCODER
ENCODER SCALING
MIN/MAX SPEED SET.
CHANNEL MODE
CHANGE ACCESS CODE
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
STOP
1: 0 m/min
LOCK SERVICE SETTINGS 1 OF 3
RETURN
ENTER NEW ACCESS CODE: ----
STOP
1: 0 m/min
123
RETURN
CONTRAST +
CONTRAST-
RETURN
LANGUAGE
LOAD PROGRAM
CHANNEL : TRIGGER
TRIGGER LOCK
CHANNEL : ENCODER
ENCODER SCALING
MIN/MAX SPEED SET.
CHANNEL MODE
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
STOP
1: 0 m/min
SERVICE SETTINGS 1 OF 3
123
Page 4-- 22
Manual #50-14 Revised 8/08
C. 1998
Change Security Lock
In this menu it is possible to lock individual functions to
prevent unauthorized modification. Additionally it is
possible to change the access code. You can
lock/unlock every above mentioned function. After
locking, these functions are only available via an
access code. Locking/Unlocking is possible only if you
know the access code.
Press button 9.
Enter Access Code.
Press Enter Button.
Use t he numeric keys to select the function
that you want to lock or unlock.
Note! Functions labeled with a are
protected against modifying by an access
code.
Change Access Code
Press button 9.
Enter the new access code using the
numeric keys.
Press Enter Button.
Note! Write down the access code and store in a
safe place.
Press F4 to return to previous menu.