ITW Dynatec DY 2008 - Pressure Assignment

RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
123
RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
123
2: 0 m/min
3: 0 m/min
4: 0 m/min
Manual #50-14 Revised 8/08
Page 4-- 25
C. 1998
Pressure Assignment
Use this menu to assign each of the pressure control
outputs to one of the encoders or to shut the output off.
Press button 3.
Enter Access Code if this function is
protected.
Press Enter Button.
Use buttons F1 or F2 to select the pressure
output.
Press button F3 to select the encoder you
want to assign the pressure output to or to
shut the output off.
Confirm the selection with t he Enter button
and repeat the procedure for the next
pressure output.
Press F4 to return to previous menu.
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
PRESSURE : ENCODER ASSIGNMENT MENU
ENCODER
OUTPUT
1
2
3
4
4: 0 m/min
RETURN
EN.1
EN.1
EN.1
EN.1
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
PRESSURE : ENCODER ASSIGNMENT MENU
ENCODER
OUTPUT
1
2
3
4
4: 0 m/min
RETURN
EN.2
EN.1
EN.1
EN.1
1
EN.2