ITW Dynatec DY 2008 - Pressure Signaling

RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
123
2: 0 m/min
3: 0 m/min
4: 0 m/min
2
RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
123
RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
123
2: 0 m/min
3: 0 m/min
4: 0 m/min
Page 4-- 24
Manual #50-14 Revised 8/08
C. 1998
Press F4 to return to previous menu.
Pressure Signaling
Use this menu to configure the pressure control
outputs.
Press button 2.
Enter Access Code if this function is
protected.
Press Enter Button.
Note! Refer to the data sheet of the I/P-- or
U/P--transducer for proper setting.
Press F 1 or F2 to select the pressure output
(#1 = X24, #2 = X25, #3 = X26, #4 = X27 on
back of control).
Press button F3 to toggle between 0 to
10V/0--20mA or 4 to 20mA.
Confirm the selection with t he Enter button
and repeat the procedure for the next
pressure output.
Press F4 to return to previous menu.
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
PRESSURE SIGNALING MENU
0-10V or 0-20mA 4-20mA
OUTPUT
1
2
3
4
4: 0 m/min
RETURN
4-20mA
4-20mA
4-20mA
4-20mA