ITW Dynatec DY 2008 - Service Settings Menu 2

STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
123
2: 0 m/min
3: 0 m/min
4: 0 m/min
1
RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
Manual #50-14 Revised 8/08
Page 4-- 23
C. 1998
Service Settings Menu 2 (of 3) Programming
Assure STOP is active.
Press Service Button until you see the menu
at right.
Use the buttons 1 to 9 to select one of the listed
functions.
Trigger Setup
Use this menu to select the properties of the trigger
devices used (NPN or PNP).
Press button 1.
Enter Access Code if this function is
protected.
Press Enter Button.
Use button F1 or F2 to select a trigger input.
Press button F3 to change the trigger type
from NPN to PNP and vice versa.
Press Enter button and repeat previous
steps for additional trigger inputs.
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
TRIGGER SETUP MENU
NPN / PNP
NPN
NPN
NPN
NPN
TRIGGER
1
2
3
4
4: 0 m/min
RETURN
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
TRIGGER SETUP MENU
NPN / PNP
NPN
NPN
NPN
NPN
TRIGGER
1
2
3
4
4: 0 m/min
RETURN